HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 19
1 - OVERVIEW OF THE HP EFS
WAN A
CCELERATOR
8. On HP EFS WAN Accelerator-3, at the system prompt, enter the following
set of commands:
SH3 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version min
6
SH3 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version max
6
SH3 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version min
6
SH3 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version max
6
SH3 (config) # write memory
SH3 (config) # restart
Run the 2.1 software for a period of time to ensure stability.
Each time a new HP EFS WAN Accelerator is upgraded to 2.1, you must
configure each of the HP EFS WAN Accelerators already running 2.1 to
communicate with it using the 2.1 protocol. For example, if HP EFS WAN
Accelerator-4 is upgraded to 2.1.
1. On HP EFS WAN Accelerator-1, at the system prompt, enter the following
set of commands:
SH1 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version min
6
SH1 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version max
6
SH1 (config) # write memory
SH1 (config) # restart
2. On HP EFS WAN Accelerator-2, at the system prompt, enter the following
set of commands:
SH2 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version min
6
SH2 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version max
6
SH2 (config) # write memory
SH2 (config) # restart
3. On HP EFS WAN Accelerator-3, at the system prompt, enter the following
set of commands:
SH3 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version min
6
SH3 (config) # sport peer <HP EFS WAN Accelerator-4 IP addr> version max
6
SH3 (config) # write memory
SH3 (config) # restart