HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)
42 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
The system confirms your settings.
You have entered the following information:
1. Hostname: minna
2. Use DHCP: no
3. Primary IP address: 10.0.0.74
4. Netmask: 255.255.0.0
5. Default gateway: 10.0.0.1
6. Primary DNS server: 10.0.0.2
7. Domain name: mydomain.com
8. Admin password: (unchanged)
9. Copy config from another site: no
10. Set the primary interface speed: 100
11. Set the primary interface duplex: full
12. Would you like to activate the in-path configuration: no
13: Would you like to activate the out-of-path configuration? yes
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
The HP EFS WAN Accelerator configuration wizard automatically saves
your configuration settings.
15. To log out of the system, enter the following command at the system
prompt:
cli> exit
Connecting the
HP EFS WAN
Accelerator to
Your Network
Use a CAT-5E straight-through cable to connect the NIC1 (Primary) port of the
HP EFS WAN Accelerator to the LAN switch in an out-of-path configuration.
To connect the HP EFS
WAN Accelerator to
your network
Plug the straight-through cable into the NIC1 (Primary) port of the HP EFS
WAN Accelerator and the LAN switch. (This can be any port on your LAN
switch which is configured to connect to a host.)
For the HP ProLiant DL320-510, DL320-1010, and DL320-2010, refer to
Figure 2-4 on page 27, item 5.
For the HP ProLiant DL380-3010 and DL380-5010, refer to Figure 2-5 on
page 28, item 9.