HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 33

2 - INSTALLING AND

ONFIGURING THE HP EFS

To configure the HP

EFS WAN Accelerator

1. To start the configuration wizard, enter yes at the system prompt. For

example:

Configuration wizard.

Do you want to use the wizard for initial configuration? yes

TIP: Press ENTER to enter the default value. Press '?' for help. Press CTRL-B to go back

to the previous step. If you mistakenly answer no, you can restart the configuration

wizard by entering configuration jump-start at the system prompt.

2. To configure the host name for the HP EFS WAN Accelerator, enter the

host name at the system prompt. For example:

Step 1: Hostname? minna

3. You are given the option to enable the Dynamic Host Configuration

Protocol (DHCP) to automatically assign an IP address to the primary

interface (that is, the HP EFS WAN Accelerator). HP recommends you do

not set DHCP. The default value is no. For example:

Step 2: Use DHCP? no

4. To configure the primary interface for the HP EFS WAN Accelerator, enter

the IP address you want to assign to the HP EFS WAN Accelerator at the

system prompt. For example:

Step 3: Primary IP address? 10.0.0.74

5. To configure the netmask, enter the netmask address at the system prompt.

For example:

Step 4: Netmask? 255.255.0.0

6. To configure the default gateway for the HP EFS WAN Accelerator, enter

the IP address at the system prompt. For example:

Step 5: Default gateway? 10.0.0.1

This value sets the default gateway to your network for optimization,

logging, Simple Network Management Protocol (SNMP) traps, and

Management Console access.

7. To configure the primary Domain Name Service (DNS), enter the IP

address of the DNS server at the system prompt. For example:

Step 6: Primary DNS server? 10.0.0.2

8. To configure the domain name for the system, enter the domain name at

the system prompt. For example:

Step 7: Domain name? mydomain.com

If you configure a domain name, you can enter host names in the system

without the domain name.