HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR INSTALLATION AND CONFIGURATION GUIDE 29

2 - INSTALLING AND

ONFIGURING THE HP EFS

* x8 PCI Express cards are supported and will run at x4 speeds.

NOTE:

Each PCI-X expansion slot could contain one of the following bypass cards:

 Two-port Copper Gig-E bypass card

 Two-port Fiber Gig-E bypass card

 HP EFS N4c WAN Accelerator 4-port NIC

Only one type of card is allowed in the system, and only one each of the two-

port copper Gig-E bypass card and two-port fiber Gig-E bypass card is

allowed in the system. Up to three four-port copper Gig-E bypass cards are

allowed in the system.

Therefore, the allowable configurations are:

1 - Two-port copper Gig-E bypass card

1 - Two-port fiber Gig-E bypass card

1-, 2-, or 3- HP EFS N4c WAN Accelerator 4-port NIC

NIC Port LabelingTerminology Note

Labeling for the NIC ports can vary. To avoid confusion, the table below

outlines the different labels for the NIC ports.

Powering On the HP EFS WAN Accelerator

The following section describes how to connect the Alternating Current (AC)

power and how to power on the HP EFS WAN Accelerator.

12 Video connector

13 VHDCI SCSI connector (port 1)

Location Label 1 Label 2

In documentation, Command Line interface, and

graphical user interface

Primary AUX

HP ProLiant DL320-510, DL320-1010, and DL320-2010 NIC1 NIC2

HP ProLiant DL380-3010 and DL380-5010 1 2

Item Description