HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

26 2 - INSTALLING AND CONFIGURING THE HP EFS WAN ACCELERATOR
 A standard electronic environment where the ambient temperature is
between 10
º C and 35º C (50º F and 95º F) and the relative humidity is
between 10% and 90% (non-condensing). For detailed information, see
Appendix A, “Status Lights, Technical Specifications, and Regulatory
Information.”
 Ethernet connections available within the standard Ethernet limit.
 Space on a two or four post 19-inch rack.
 A clean power source dedicated to computer devices and other electronic
equipment.
Required Tools and Equipment
You need the following tools and equipment to mount the HP EFS WAN
Accelerator to a rack:
 A standard 19 inch Telco-type mounting rack. The HP ProLiant DL380-
3010 and DL380-5010 require 2 Units (U) of rack space. The HP ProLiant
DL320-510, DL320-1010, and DL320-2010 require 1 U of rack space.
 Appropriate screwdriver for screws if mounting into a threaded-hole
rack. Refer to the instructions that came with the rack mount kit. Also
refer to the documentation that came with your system for important rack
planning resource instructions.
NOTE: If mounting to a two-post rack, go to http://www.racksolutions.com/hp.
Required Configuration Information
Before you begin the installation and configuration process, gather the
necessary configuration information:
 Host name for the HP EFS WAN Accelerator
 Internet Protocol (IP) address for the HP EFS WAN Accelerator
 Netmask
 Default gateway (the WAN gateway)
 Domain Name Service (DNS) IP address
 Domain name for the system
 For in-path configurations: in-path interface IP address, in-path netmask,
and in-path default gateway