HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Installation and Configuration Guide (November 2005)

18 1 - OVERVIEW OF THE HP EFS WAN ACCELERATOR
The following upgrade instructions assume that you have a network of 10 HP
EFS WAN Accelerators. In this example, you upgrade part of your network,
then upgrade the remaining HP EFS WAN Accelerators.
To upgrade from 1.2 to
2.1
1. Connect to the Management Console on each HP EFS WAN Accelerator.
2. Install the 2.1 image in the Setup: Software Upgrade page.
3. Save the current configuration in the Setup: Configuration Manager page.
4. Reboot the HP EFS WAN Accelerator in the Setup: Reboot Appliance page.
5. Connect to the CLI on each of the 3 HP EFS WAN Accelerators that you
want to upgrade.
6. At the system prompt, enter the following set of commands:
SH > enable
SH # configure terminal
SH (config) # sport peer 0.0.0.0 version min 5
SH (config) # sport peer 0.0.0.0 version max 5
This set of commands ensures that the 2.1 HP EFS WAN Accelerators can
communicate with all the 1.2 appliances in your network.
To take advantage of the 2.1 features, you need to configure the 2.1 HP EFS
WAN Accelerator
s to communicate with each other using the 2.1 protocol.
7. On HP EFS WAN Accelerator-1, at the system prompt, enter the following
set of commands:
SH1 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version min
6
SH1 (config) # sport peer <HP EFS WAN Accelerator-2 IP addr> version max
6
SH1 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version min
6
SH1 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version max
6
SH1 (config) # write memory
SH1 (config) # restart
8. On HP EFS WAN Accelerator-2, at the system prompt, enter the following
set of commands:
SH2 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version min
6
SH2 (config) # sport peer <HP EFS WAN Accelerator-1 IP addr> version max
6
SH2 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version min
6
SH2 (config) # sport peer <HP EFS WAN Accelerator-3 IP addr> version max
6
SH2 (config) # write memory
SH2 (config) # restart