HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

38 3 - ENABLE-MODE COMMANDS
Example minna (config) # show in-path peering rules
Rule Type Source Network Dest Network Port Peer Addr
----- ------ ------------------ ------------------ ----- -------------
1 pass * * * 10.0.1.3
2 pass * * * 10.0.1.
def auto * * * *
show in-path rules
Description Displays current in-path rules and Virtual Local Area Network (VLAN) identification
numbers.
Syntax show in-path rules
Parameters None
Example
minna (config) # show in-path rules
Rule Type O N VLAN Source Addr Dest Addr Port
----- ---- - - ---- ------------------ ------------------ -------------
1 pass - - all all all Secure
2 pass - - all all all Interactive
def auto F A all all all all
-----------------------------------------------------------------------
2 user added rule(s)
(O) Optimization Policy: F=Full S=SDR-Only C=Compr-Only N=None
(N) Neural Framing: N=Never A=Always T=TCP Hints D=Dynamic
show interfaces
Description Displays the running state settings (which might be different due to Dynamic Host
Configuration Protocol (DHCP)) and statistics.
Syntax show interfaces [<intname>] | [brief | configured]
Parameters
Example
minna # show interfaces
Interface lo state
Up: yes
IP address: 127.0.0.1
Netmask: 255.0.0.0
Speed:
Duplex:
Interface type: loopback
MTU: 16436
HW address: XX:XX:XX:XX:XX
RX bytes: 656
RX packets: 12
RX mcast packets: 0
RX discards: 0
RX errors: 0
<intname> Specifies the name of the interface.
brief Displays the running state settings without statistics.
configured Displays configured settings for the interface.