HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)
HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 33
3 - ENABLE-MODE COMMANDS
Example minna # show configuration running
##
## Network interface configuration
##(displays running configuration; this is a partial example.)
show connections
Description Displays connections running through the HP EFS WAN Accelerator.
Syntax show connections
[all | optimized | passthrough | opening | closing] [filter <filter-string>] [sort-by
<state> | srcip | srcport | destip | destport |peerip | peerport | app | reduction |
bytes_in | bytes_out | starttime] [full]
Parameters
optimized Specifies the total active connections optimized.
passthrough Specifies the total connections passed through, unoptimized.
opening Specifies the total half-opened active connections. A half-
opened connection is a Transmission Control Protocol (TCP)
connection in which the connection has not been fully
established. Half-opened connections count toward the
connection count-limit on the HP EFS WAN Accelerator
because at any time they might become a fully opened
connection. If you are experiencing a large number of half-
opened connections, you might consider an appropriately
sized HP EFS WAN Accelerator.
closing Specifies the total half-closed active connections. A half-
closed connection is a TCP connection which has been closed
on one side. The other side of the connection can still send
data. These connections count toward the HP EFS WAN
Accelerator connection count-limit. If you experience a large
number of half-closed connections, you might consider an
appropriately sized HP EFS WAN Accelerator.
filter <filter-string> Filters connections according to string.
sort-by <state> srcip |
srcport | destip | destport |
peerip | peerport | app |
reduction| bytes_in |
bytes_out | starttime
Sort results by the following states:
• srcip. Sort connections by source Internet Protocol (IP)
address.
• srcport. Sort connections by source port.
• destip. Sort connections by destination IP address.
• peerip. Sort connections by peer IP address.
• peerport. Sort connections by peer port.
• app. Sort connections by application such as HyperText
Transfer Protocol (HTTP).
• reduction. Sort connections by percent of reduction in
bandwidth.
• bytes_in. Sort connections by total number of bytes in.
• bytes_out. Sort connections by total number of bytes out.
• starttime. Sort connections by start time.