HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 133
4 - CONFIGURATION-MODE
C
OMMANDS
NOTE: Any change in the connection pooling parameter requires you to restart the HP EFS
WAN Accelerator service.
Syntax service connection pooling <addr> <value>
Parameters
minna (config) # service connection pooling 10.0.0.1 10
minna (config) #
service default-port
Description Sets the default service port you want to use for connection pooling.
Syntax service default-port <port>
Parameters
Example
minna (config) # service default-port 7800
minna (config) #
service enable
Description Starts the HP EFS WAN Accelerator service. The no command option disables the
HP EFS WAN Accelerator service (that is, it disables all the configured in-path IP
addresses and ports and you lose your connection to the Management Console).
Syntax service enable
Parameters None
Example
minna (config) # service enable
minna (config) #
service error reset
Description Resets the HP EFS WAN Accelerator service after a service error.
Syntax service error reset
<addr> Specifies the IP address of the peer HP EFS WAN Accelerator. The IP
address of 0.0.0.0 identifies the group of all HP EFS WAN Accelerator
peers.
<value> Specifies the connection pooling value for the HP EFS WAN Accelerator
peer. The default value is 20.
<port> Specifies the new port.