HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

HP STORAGEWORKS EFS WAN ACCELERATOR COMMAND-LINE INTERFACE REFERENCE MANUAL 109

4 - CONFIGURATION-MODE

OMMANDS

pfs auto-launch enable

Description Enables Proxy File Service (PFS) process to start automatically. If PFS is set to

manual (the default setting), you must start PFS manually using the pfs start

command.

For detailed information about PFS, see the HP StorageWorks Enterprise File Services

WAN Accelerator Deployment Guide.

NOTE: To enable PFS you must have an HP EFS WAN Accelerator, Model DL320-1010,

DL320-2010, DL380-3010, or DL380-5010.

Syntax pfs auto-launch enable

Parameters

None

Example minna (config) # pfs auto-launch enable

pfs configure

Description Configures the file share on the HP EFS WAN Accelerator. To enable Proxy File

Service (PFS) support, you must have an HP EFS WAN Accelerator, Model DL320-

1010, DL320-2010, DL380-3010, or DL380-5010.

For detailed information about PFS, see the HP StorageWorks Enterprise File Services

WAN Accelerator Deployment Guide.

IMPORTANT: The HP EFS WAN Accelerator host name must be in the DNS database for the

HP EFS WAN Accelerator to join the domain. Host names with greater than 15 characters

prevent the HP EFS WAN Accelerator from joining the domain. Make sure your HP EFS WAN

Accelerator host name is less than 15 characters for PFS configurations.

Syntax pfs configure {realm <domain name>

[dc-name <domain controller>]}