HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

40 3 - ENABLE-MODE COMMANDS
Syntax show ip {default gateway [static] |in-path route <interface>in-pathgateway
<interface>route [static]}
Parameters
Example
minna # show ip route
Destination Mask Gateway
10.0.0.0 255.255.0.0 0.0.0.0
default 0.0.0.0 10.0.0.1
minna #
show ip security
Description Displays IP Security Protocol (IPSec) settings. IPsec security support must also be
running when IP security is enabled, if both are not enabled a problem could result
with your security settings.
Syntax show ip security
Parameters None
Example
minna # show ip security
IP security enabled: yes
PFS enabled: yes
IKE rekeying interval: 240
Encryption policy: des
Authentication policy: hmac_md5
IP security is running: yes
show ip security peers
Description Displays IPsec security settings for peer HP EFS WAN Accelerators. The show ip
security peers command displays a static configuration and might not reflect that
actual IPsec connections that are established. If a connection has not been made
between the two HP EFS WAN Accelerators that are configured to use IPsec security,
then it does not display the peer HP EFS WAN Accelerator because a security
association has not yet been established.
Syntax show ip security peers
Parameters None
default gateway
[static]
Displays the default gateway or static default gateway.
in-path route
<interface>
Displays in-path route settings for inpath0_0, inpath1_1.
in-path-gateway
<interface>
Displays in-path gateway settings for inpath0_0, inpath1_1.
route [static] Displays the IP route or IP static route.