HP StorageWorks Enterprise File Services WAN Accelerator 2.1 Command Line Interface Reference Guide (November 2005)

134 4 - CONFIGURATION-MODE COMMANDS
Parameters None
Example
minna (config) # service error reset
minna (config) #
service map-port
Description Sets a target port to service port mappings. Setting multiple service ports on inner
connections enables you to identify the type of traffic and apply QoS settings based
on a port. The no command option disables the service map.
For example, in an in-path deployment, CIFS and MAPI could be mapped to port 9800
and HTTP to port 9802. The you can configure the WAN router to tag packets for port
9800 with the same priority as for CIFS and MAPI, and those for port 9802, with the
same priority as HTTP.
In the out-of-path deployment, you define which port to listen to on the server HP EFS
WAN Accelerator and you define an in-path fixed-target rule on the client HP EFS
WAN Accelerator to point to the service ports for the traffic you want to apply QoS to.
You cannot map the following ports.
Syntax service map-port <dest port> <service port>
Parameters
Example
minna (config) # service map-port 7018 8000
minna (config) #
Port Description
22 Reserved for Secure Shell (SSH).
80, 443, and 446 Reserved for the Management Console.
139, 445, and 977 Reserved for Proxy File Service (PFS). These ports are only
excluded if you have PFS enabled.
7800-7899 Reserved by HP (except 7800 and 7810).
8777 Reserved for CIFS transparent prepopulation;. This port is
excluded only if you have CIFS prepopulation enabled.
<dest port> Specifies the destination port you want to map.
<service port> Specifies the service port you want to map to.