HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Utilities and Exercisers
90 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
2. Set the terminal to Nowrap mode to prevent the top line of the display from
scrolling off of the screen.
3. Press Enter or Return to display the CLI prompt.
4. Start VTDPY with the following command:
RUN VTDPY
Use the key sequences and commands listed in Table 17 to control VTDPY.
Commands can be abbreviated to the minimum number of characters necessary to
identify the command. Enter a question mark (?) after a partial command to see
the values that can follow the supplied command.
Table 17: VTDPY Key Sequences and Commands
Command Action
Ctrl+C Enables Command mode; after entering Ctrl+C, enter one of the
following commands, and press Enter or Return:
■ CLEAR
■ DISPLAY CACHE
■ DISPLAY DEFAULT
■ DISPLAY DEVICE
■ DISPLAY HOST
■ DISPLAY REMOTE (ACS V8.8P only)
■ DISPLAY RESOURCE
■ DISPLAY STATUS
■ EXIT or QUIT
■ HELP
■ INTERVAL seconds (to change update interval)
■ REFRESH or UPDATE
Ctrl+G Updates screen.
Ctrl+O Pauses (and resumes) screen updates.
Ctrl+R Refreshes the current screen display.
Ctrl+W Refreshes the current screen display.
Ctrl+Y Exits VTDPY.