HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes
249HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
080A0000 The “other controller” requested “this controller” to self-test. 00
080B0100 Could not get enough memory to build a FCB to send to the remote
routines on the “other controller.”
01
080C0100 Could not get enough memory for FCBs to receive information from the
“other controller.”
01
080D0100 Could not get enough memory to build a FCB to reply to a request from
the “other controller.”
01
080E0101 An out-of-range receiver ID was received by the NVFOC communication
utility (master send to slave send ACK):
Last failure parameter [0] contains the bad ID value.
01
080F0101 An out-of-range receiver ID was received by the NVFOC communication
utility (received by master):
Last failure parameter [0] contains the bad ID value.
01
08100101 A call to NVFOC$TRANSACTION had a From field (ID) that was out of
range for the NVFOC communication utility:
Last failure parameter [0] contains the bad ID value.
01
08110101 NVFOC tried to defer more than one FOC send:
Last failure parameter [0] contains the master ID of the connection that
had the multiple delays.
01
08140100 Could not allocate memory to build a workblock to queue to the NVFOC
thread.
01
08160100 A request to clear the remote configuration was received, but the
memory was not locked.
01
08170100 A request to read the next configuration was received, but the memory
was not locked.
01
08180100 Could not get enough memory for Firmware Licensing System (FLS) FCBs
to receive information from the “other controller.”
01
08190100 An unlock command was received while the NV memory was not locked. 01
081A0100 Unable to allocate memory for remote work. 01
Table 56: Last Failure Codes and Repair Action Codes (Sheet 36 of 55)
Last
Failure
Code
Description
Repair
Action
Code