HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Instance Codes
193HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
02925D01 The device, specified in the Device Locator field, was
removed from the spareset into the failedset; there are
no devices left in the spareset. The new nominal
number of members for the spareset is specified in the
device sense data Information field.
51 5D
02931101 The UPS signaled a TMW before signaling an AC line
failure. UPS signals are ignored until this condition
clears.
12 11
0294000A A requested block of data contains a forced error. A
forced error occurs after a disk block is successfully
reassigned, but the data in that block is lost. Rewriting
the disk block clears the forced error condition. The
Information field of the device sense data contains the
block number of the first block in error.
51 00
0295000A The Snapshot unit, indicated by the Unit Number
field, is disabled. Reads to the unit fails. Reasons for
disabling the Snapshot are a failure to copy to the
temporary storageset, or no room on the temporary
storageset to properly fail over the Snapshot.
51 00
02965E0A The single member mirror has an error in its metadata
space which could not be corrected. Backup data
from the mirror as soon as possible.
51 5E
03010101 No command control structures available for disk
operation. In this instance, the associated ASC and
associated ASCQ fields are undefined.
41 01
03022002 SCSI INTERFACE CHIP command timeout
occurred during disk operation. In this instance, the
associated ASC and associated ASCQ fields are
undefined.
41 20
03034002 Byte transfer timeout during disk operation. In this
instance, the associated ASC and associated ASCQ
fields are undefined.
41 40
Table 53: Instance Codes and Repair Action Codes (Sheet 13 of 30)
Instance
Code
Description Template
Repair
Action
Code