HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes
251HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
09C90101
09CA0101
Remote FLM detected an invalid work type:
Last failure parameter [0] contains the work type found.
01
09CB0012 Remote FLM detected that the “other controller” has a facility lock
manager at an incompatible revision level (with “this controller”) :
Last failure parameter [0] contains the “this controller” FLM revision.
Last failure parameter [1] contains the “other controller” FLM revision.
00
0A020100 ILF$CACHE_READY unable to allocate necessary DWDs. 01
0A030100 ILF$CACHE_READY BUFFERS_OBTAINED > non-zero stack entry
count.
01
0A040100 ILF$CACHE_READY DWD overrun. 01
0A050100 ILF$CACHE_READY DWD underrun. 01
0A060100 ILF$CACHE_READY found buffer marked for “other controller.” 01
0A070100 CACHE$FIND_LOG_BUFFERS returned continuation handle > 0. 01
0A080100 Not processing a bugcheck. 01
0A090100 No active DWD. 01
0A0A0100 Current entry pointer is not properly aligned. 01
0A0B0100 Next entry pointer is not properly aligned. 01
0A0E0100 Active DWD is not a disk write DWD as expected. 01
0A0F0100 New active DWD is not a disk write DWD as expected. 01
0A100100
0A120100
0A130100
Data buffer pointer is not properly aligned. 01
0A140100 New entry pointer is not properly aligned. 01
0A150100 New entry record type is out of range. 01
0A190102 ILF_DEPOPULATE_DWD_TO_CACHE first page guard check failed:
Last failure parameter [0] contains the DWD address value.
Last failure parameter [1] contains the buffer address value.
01
Table 56: Last Failure Codes and Repair Action Codes (Sheet 38 of 55)
Last
Failure
Code
Description
Repair
Action
Code