HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)
Last Failure Codes
248 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
06070100 The DUART was unable to allocate enough memory for its input buffers 01
06080000 Controller was forced to restart due to entry of a Ctrl+K character on the
maintenance terminal.
00
07010100 All available slots in the FOC notify table are filled. 01
07020100 FOC$CANCEL_NOTIFY( ) was called to disable notification for a
return that did not have notification enabled.
01
07030100 Unable to start the Failover control timer before main loop. 01
07040100 Unable to restart the Failover control timer. 01
07050100 Unable to allocate flush buffer. 01
07060100 Unable to allocate active receive Failover Control Block (FCB). 01
07070100 The “other controller” made this inoperative, but could not assert the kill
line because nindy is on or in debug. It made this inoperative now.
01
07080000 The “other controller” failed, so this one must fail too. 00
07090100 A call to EXEC$ALLOCATE_MEM_ZEROED failed to return memory
while allocating VA Request Items.
01
08010101 A remote state change was received from the FOC thread that
Nonvolatile FOC (NVFOC) does not recognize:
Last failure parameter [0] contains the unrecognized state value.
01
08020100 No memory could be allocated for a NVFOC information packet. 01
08030101 Work received on the S_NVFOC_BQUE did not have a NVFOC work
ID:
Last failure parameter [0] contains the ID type value that was received on
the
NVFOC work queue.
01
08040101 Unknown work value received by the S_NVFOC_BQUE:
Last failure parameter [0] contains the unknown work value.
01
08060100 A write command was received while the NV memory was not locked. 01
08070100 A write to NV memory was received while not locked. 01
08080000 The “other controller” requested “this controller” to restart. 00
08090010 The “other controller” requested “this controller” to shut down. 00
Table 56: Last Failure Codes and Repair Action Codes (Sheet 35 of 55)
Last
Failure
Code
Description
Repair
Action
Code