HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Command Line Interface Reference Guide (EK-G80CL-RA. C01, March 2005)

CLI Command Descriptions
115HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software
Command Line Interface Reference Guide
Forces the controller to copy the subsystem configuration information in its
NVRAM memory onto a configuration file on the disk array. This allows you to
know whether a copy of the configuration is saved. The command takes effect
immediately.
Tip: Use the INITIALIZE container-name SAVE_CONFIGURATION
command to set up the location of the configuration file on the specified container and
to save the current subsystem configuration.
The controller updates the configuration file on the disk array after configuration
changes. This command forces an immediate update. In single-controller subsystems,
the configuration is saved on the disk array. If a container had the
SAVE_CONFIGURATION switch specified while it was initialized (through the
INITIALIZE command), the disks that constitute that container (excluding JBODs)
are able to save a copy of the configuration. If the container is a JBOD, the container
must be made a unit in order for the configuration to be saved on it.
Note: Use this command for a single controller configuration only. HP does not
recommend using this command on controllers in a dual-redundant configuration.
Syntax
CONFIGURATION SAVE
Parameters
There are no parameters associated with this command.
Switches
There are no switches associated with this command.
CONFIGURATION SAVE