HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Last Failure Codes
268 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
8A040080 New cache module failed diagnostics. The controller was reset to clear
the error.
00
8A050080 Could not initialize new cache module. The controller was reset to clear
the error.
00
8B000186 An single bit error was found by software scrubbing:
Last failure parameter [0] contains the address of the first single bit error
correction code (ECC) error found.
Last failure parameter [1] contains the count of single bit ECC errors
found in the same region below this address.
Last failure parameter [2] contains the lower 32 bits of the actual data
read at the parameter [0] address.
Last failure parameter [3] contains the higher 32 bits of the actual data
read at the parameter [0] address.
Last failure parameter [4] contains the lower 32 bits of the expected data
at the parameter [0] address.
Last failure parameter [5] contains the higher 32 bits of the expected
data at the parameter [0] address.
01
Table 56: Last Failure Codes and Repair Action Codes (Sheet 55 of 55)
Last
Failure
Code
Description
Repair
Action
Code