HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Utilities and Exercisers
127HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
What BUFFER SIZE (in
BYTES) does the drive
require (2048, 4096,
8192) [8192]?
HSUTIL detects that an unsupported device is selected as the
target device and the firmware image requires multiple SCSI
Write Buffer commands. Specify the number of bytes to be sent in
each Write Buffer command. The default buffer size is 8192
bytes. A firmware image of 256 K, for example, can be code
loaded in 32 Write Buffer commands, each transferring 8192
bytes.
What is the TOTAL SIZE
of the code image in
BYTES [device
default]?
HSUTIL detects that an unsupported device is selected as the
target device. Enter the total number of bytes of data to be sent in
the code load operation.
Does the target device
support only the
download microcode and
save?
HSUTIL detects that an unsupported device is selected as the
target device. Specify whether the device supports the SCSI Write
Buffer command download and save function.
Should the code be
downloaded with a
single write buffer
command?
HSUTIL detects that an unsupported device is selected as the
target device. Indicate whether to download the firmware image
to the device in one or more contiguous blocks, each
corresponding to one SCSI Write Buffer command.
Table 36: HSUTIL Messages and Inquiries (Continued)
Message Description