HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Utilities and Exercisers
113HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
Runtime Status of Remote Copy Sets screen
Use the Runtime Status of Remote Copy Sets screen to check the runtime status
of all remote copy sets. Table 28 provides a description of the Remote screen
column headings and possible entries under each column.
Note: This feature is only supported in the P variant of ACS.
Table 28: Remote Display Column Definitions—ACS P Variant Only
Column Contents
COPY SET Remote copy set name.
TARGET Target connection name and target unit number.
C Connection status:
U = Connection up (online).
D = Connection down (offline).
INIT Initiator unit number.
U Availability of the unit:
a = Available to “other controller.”
d = Disabled for servicing, offline.
e = Mounted for exclusive access by a user.
f = Media format error.
i=Inoperative.
m = Maintenance mode for diagnostic purposes.
o = Online. Host can access this unit through “this controller.”
r = Rundown with the SET NORUN CLI command.
v = No volume mounted due to lack of media.
x = Online. Host can access this unit through “other controller.”
z = Currently not accessible to host due to a remote copy condition.
(space) = Unknown availability.
Kb/s Total initiator unit bandwidth in Kb per second.
ASSOC SET Association set name.
U Log unit status: uses the same codes as “U - Availability of the unit.”
Kb/s Total log unit bandwidth in Kb per second.