HP StorageWorks HSG80 ACS Solution Software V8.8 for OpenVMS Installation and Configuration Guide (AA-RV1PA-TE, March 2005)

Installing and Configuring the HSG Agent
117HSG80 ACS Solution Software V8.8 for OpenVMS Installation and Configuration Guide
Downloading the Host Kit Software From the Web
The host kit software is available for download. You can save the software to your
computer or create a CD-ROM. Platform kit software is stored on the download
web site based on operating system. Follow the steps below to obtain the software
from the web site.
1. Go to
http://h18006.www1.hp.com/products/storageworks/ma8kema12k/kits.html .
2. Select the kit for download.
3. Select the folder in which you want to save the file when presented with the
Save As dialog box.
Note: The folder you select must be large enough to store the OS kit selected. File
sizes range from 862KB to 51 MB depending on the operating system selected.
The platform kit software is available as an .iso or .zip file. After you download it
to your computer, your options are:
■ Create a CD-ROM using the .iso file.
■ Copy the .zip file to the server that runs the platform kit software.
Uncompress the file and run the install program on the server.
Installing and Configuring the Agent
The following SWCC Agent install procedure assumes that you have loaded the
web kit to a CD-ROM (see “SWCC Features and Components” on page 112). For
the following examples, you can replace DQA0 and DKB100:[SWCC] with “device
names” more suitable for your system.
1. Insert the CD-ROM into the system that is connected to the controller.
For the examples in this section, assume the CD-ROM device is DQA0.
2. To mount the CD-ROM, enter the following at the command prompt (Replace
DQA0 with the name of your CD-ROM device.):
$ MOUNT/OVER=ID/MEDIA=CD DQA0: