HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

Utilities and Exercisers
72 HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide
Table 13: FMU SET Commands
Command Result
SET EVENT_LOGGING
SET NOEVENT_LOGGING
Enables and disables the spontaneous display of significant
events to the local terminal; preceded by %EVL (see example
in the section, “Spontaneous Event log,” that starts on
page 40). By default, logging is enabled (SET
EVENT_LOGGING).
If logging is enabled, the controller spontaneously displays
information about the events on the local terminal.
Spontaneous event logging is suspended during the execution
of CLI commands and operation of utilities on a local
terminal. Because these events are spontaneous, logs are not
stored by the controller.
SET LAST_FAILURE LOGGING
SET NOLAST_FAILURE LOGGING
Enables and disables the spontaneous display of last failure
events; preceded by %LFL (see example in the section, “Last
failure reporting,” on page 39). By default, logging is
enabled (SET LAST_FAILURE LOGGING).
The controller spontaneously displays information relevant to
the sudden termination of controller operation.
In cases of automatic hardware reset (for example, power
failure or pressing the controller Reset button), the fault LED
log display is inhibited because automatic resets do not allow
sufficient time to complete the log display.
SET log_type REPAIR_ACTION
SET log_type NOREPAIR_ACTION
Enables and disables the inclusion of repair action
information for event logging or last failure logging. By
default, repair actions are not displayed for these log types
(SET log_type NOREPAIR_ACTION). If the display of
repair actions is enabled, the controller displays any of the
recommended repair actions associated with the event.
SET log_type VERBOSE
SET log_type NOVERBOSE
Enables and disables the automatic translation of event codes
that are contained in Event logs or last failure logs. By default,
this descriptive text is not displayed (SET log_type
NOVERBOSE). See “Translating event codes” on page 70 for
instructions to translate these codes manually.