HP StorageWorks HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide (EK-G80TS-SA. C01, March 2005)

ManualsBrandsHP ManualsSoftwareHP StorageWorks HSG60 ACS V8.xL to V8.8G Upgrade Software

251

252

253

254

255

256

257

258

259

260

Last Failure Codes

259HSG60 and HSG80 Array Controller and Array Controller Software Troubleshooting Guide

12130108 An internal consistency check has diagnosed an FX chip hang. The

resulting reboot resets the chip. The parameters contain values intended

for use by the software developers:

Last failure parameter[0] contains the FX DMA time check.

Last failure parameter[1] contains the FX DMA active flag.

Last failure parameter[2] contains the FX DMA step.

Last failure parameter[3] contains the FX DMA XOR count.

Last failure parameter[4] contains the FX DMA Zero count.

Last failure parameter[5] contains the FXWI state.

Last failure parameter[6] contains the FX wait queue count.

Last failure parameter[7] contains the FX ring queue count.

12140100 An attempt to allocate a free VAR failed. 01

12150100 An attempt to allocate a free VAR failed. 01

20010100 The action for work on the CLI queue should be CLI_CONNECT,

CLI_COMMAND_IN or CLI_PROMPT. If it is not one of these three, a

bugcheck results.

20020100 The Formatted ASCII Output (FAO) returned a non-successful response.

This response happens only if a bad format is detected or the formatted

string overflows the output buffer.

20030100 The type of work received on the CLI work queue was not of type CLI. 01

20060100 A work item of an unknown type was placed on the CLI SCSI virtual

terminal thread work queue by the CLI.

20080000 “This controller” requested “this controller” to restart. 00

20090010 “This controller” requested “this controller” to shut down. 00

200A0000 “This controller” requested “this controller” to self-test. 00

200B0100 Could not get enough memory for FCBs to receive information from the

“other controller.”

200D0101 DS$PORT_BLOCKED failed to return a false status (which signals that

nothing is blocked):

Last failure parameter [0] contains the port number 1–6 (or port 1–2 on

the HSG60); waiting to be unblocked.

Table 56: Last Failure Codes and Repair Action Codes (Sheet 46 of 55)

Last

Failure

Code

Description

Repair

Action

Code