SAN Switch 2/8 V3.1.x - Installation Guide

Installing the SAN Switch 2/8
52 SAN Switch 2/8 Version 3.1.x Installation Guide
— For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washers and two #10 alignment washers in
the upper and lower hole locations of the right rail. Then install two
#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers
and two #10 alignment washers in the upper and lower hole locations of
the left rail. See Figure 19.
Figure 19: Assembling the outer rails (HP System/e rack)