HP Surestore FC 1Gb/2Gb Switch 8B Installation and Reference Guide

2-12 Installation and Reference Guide
Installing and Configuring the Switch
2
5. Assemble the outer rails by completing the following steps:
a. As an aid in assembly, two rubber washers have been included to help keep the rear slotted
portion of the outer rail flush against the rear rail-tray brackets. Install them as shown in
Figure 2-11.
Figure 2-11 Installing the Rubber Washers
b. Insert the alignment pins attached to the outer rail front flange into the center opening in
the rack.
Note: The alignment pins will be resting on the top surfaces of the spacers.