HP Surestore FC 1Gb/2Gb Switch 8B Getting Started Guide

Installing the Switch 3
Package Contents
The major items included in the shipping carton(s) include the following
items:
• One FC Entry Switch 8B or FC Switch 8B
• One 10 ft. RS-232 serial cable (convertible to an RJ-45 connector by
removing the adapter on the end of the cable)
• One grounded 6 ft. power cord
• Rubber mounting feet (used only for setting up the switch as a
stand-alone unit)
• Two rails and one bag of rail mounting hardware (required if the switch
is to be installed in a rack)
• One plenum
• HP Surestore FC 1Gb/2Gb Entry Switch 8B and FC 1Gb/2Gb Switch
8B Getting Started Guide
• HP Surestore FC 1Gb/2Gb Entry Switch 8B and FC 1Gb/2Gb Switch
8B Documentation CD
Installing the Switch as a Stand-Alone Unit
This section provides instructions for setting up the switch as a stand-alone
unit on a flat surface. The following items are required:
• FC Entry Switch 8B or FC Switch 8B
• Power cord
• Rubber mounting feet
To set up the switch as a stand-alone unit:
1. Check contents of the shipping carton to verify all the required parts and
hardware are available.
2. Apply the rubber feet by completing the following steps:
CAUTION Installing the rubber feet on the switch is recommended to help
prevent the switch from accidentally sliding off the supporting surface.