HP Surestore FC 1Gb/2Gb Switch 8B Getting Started Guide

36 Getting Started Guide
• Two Ethernet port LEDs, one to show link speed and one to show link
status.
LEDs on the SFP Media Side
Figure 18 shows the SFP media side of the switch with the LEDs identified.
Figure 18. The SFP Media Side of the FC Entry Switch 8B and FC Switch 8B
Note The LEDs may flash different colors during diagnostic tests and
POST. This does not indicate a problem unless the LEDs do not display a
healthy pattern after POST or the other diagnostic tests are complete.
The following table describes the switch status LED located to the right of
the serial port on the SFP media side of the switch.
Color of LED Status of Hardware Recommended Action
No light Either the switch is off, or boot
is not complete, or boot has
failed.
Verify that the switch
is on and boot has had
time to complete. If
there is still no light,
contact HP support.
Steady green Switch is on and all ports are
ready for use.
No action required.