HP Surestore FC 1Gb/2Gb Switch 8B Getting Started Guide

Installing the Switch 15
Figure 11. Installing the Rubber Washers
b. Insert the alignment pins attached to the outer rail front flange into the
center opening in the rack.
Note The alignment pins will be resting on the top surfaces of the spacers.
c. Install one #10-32 x 5/8 Phillips pan-head screw in the upper hole
location of the right rail. Then, install one #10-32 x 5/8 Phillips
pan-head screw in the lower location of the left rail as shown in
Figure 12.
Note Do not install the upper left and lower right screws until later.