Fabric OS Reference Manual (Version 3.0)

1-52 Fabric OS Reference

Telnet Commands

diagClearError

Clear the diag software flag to allow for retest.

Synopsis diagClearError [port]

Availability admin

Description Use this command to clear the diagnostic software flag that indicates whether a port is BAD or OK.

The current flag settings are displayed by using the diagShow command. This command resets the

flag to allow the bad port to be retested; otherwise the test skips the port.

This command does not clear the error log entry. Instead, it generates the following

DIAG-CLEAR_ERR message for each port software flag cleared. For example, the following

message is for a diagnostic error cleared from port 3:

0x10f9d560 (tShell): Apr 9 08:35:50

Error DIAG-CLEAR_ERR, 3,

Pt13 (Lm3) Diagnostics Error Cleared

Err# 0001

Operands This command has the following operand:

port Specify the port where you want to reset the diagnostic software flag. Valid

values for port number vary depending on the switch type. This operand is

optional.

If no operand is specified, the default is to clear all bad port flags.

Example To clear the diag software flag: