Fabric OS Reference Manual (Version 3.0)

Fabric OS Reference 2-9
Error Messages
2
Diagnostic Error Messages
This section provides information on the probable cause of a diagnostic error and what actions to
take.
Table 2-4 Diagnostic Error Messages
Message Description Probable Cause Action
DIAG-BADINT
Err#1030, 2030
[centralMemoryTest, cmiTest]
Port received an unexpected interrupt ASIC failure Replace mainboard
assembly
DIAG-BUS_TIMEOUT
Err#0BoF, 4040F
[portRegTest,
sramRetentionTest]
ASIC register or ASIC SRAM did not
respond to an ASIC data access
ASIC failure Replace mainboard
assembly
DIAG-CAMINIT
Err#223B
[camTest]
Port failed to initialize due to one of the
following reasons:
• Switch not disabled
• Diagnostic queue absent
• Malloc failed
• Chip is not present
• Port is not in loopback mode
• Port is not active
Software operational
setup error or main
board failure
Retry, reboot or
replace mainboard
assembly
DIAG-CAMSID
Err#223C
[camTest]
ASIC failed SID NO translation test ASIC failure Replace mainboard
assembly
DIAG-CLEAR_ERR
Err#0001
Port's diag error flag (OK or BAD) is
cleared
Informational Only None required
DIAG-CMBISRF
Err#1021
[centralMemoryTest]
ASIC’s Central Memory SRAMs did not
complete the BISR within the timeout
period
ASIC failure Replace mainboard
assembly
DIAG-CMBISRTO
Err#1020
[centralMemoryTest]
ASIC’s Central Memory SRAMs did not
complete the BISR within the timeout
period
ASIC failure Replace mainboard
assembly
DIAG-CMERRPTN
Err#102B
[centralMemoryTest]
Error detected at the wrong port ASIC failure Replace mainboard
assembly