Fabric OS Reference Manual (Version 3.0)

Fabric OS Reference 1-201
Telnet Commands
1
Operands This command has the following operand:
port Specify the port number to be displayed. Valid values for port number vary
depending on the switch type. This operand is required.
Example To display a port with only the basic set of statistics:
See Also portErrShow
portShow
fl_cf_full Number of CFIFOs full stalls.
fl_cf_na CFIFO not available stalls.
fl_trig_age Number of age count triggers.
fl_trig_lp Number of loop not busy triggers.
open Number of times the FL_Port entered OPEN state.
transfer Number of times the FL_Port entered TRANSFER state.
opened Number of times the FL_Port entered OPENED state.
starve_stop Loop tenancies stopped due to starvation.
fl_tenancy Number of times FL_Port had loop tenancy.
nl_tenancy Number of times NL_Port had loop tenancy.
frame_nozone Frames rejected due to zone protection.
switch:admin> portStatsShow 3
stat_wtx 1181994 4-byte words transmitted
stat_wrx 1188458 4-byte words received
stat_ftx 95830 Frames transmitted
stat_frx 15564 Frames received
stat_c2_frx 0 Class 2 frames received
stat_c3_frx 93 Class 3 frames received
stat_lc_rx 7735 Link control frames received
stat_mc_rx 0 Multicast frames received
stat_mc_to 0 Multicast timeouts
stat_mc_tx 0 Multicast frames transmitted
tim_rdy_pri 477 Time R_RDY high priority
tim_txcrd_z 0 Time BB_credit zero
er_enc_in 0 Encoding errors inside of frames
er_crc 0 Frames with CRC errors
er_trunc 0 Frames shorter than minimum
er_toolong 0 Frames longer than maximum
er_bad_eof 0 Frames with bad end-of-frame
er_enc_out 3 Encoding error outside of frames
er_disc_c3 0 Class 3 frames discarded