Fabric OS Reference Manual (Version 3.0)

1-186 Fabric OS Reference

Telnet Commands

args The command arguments description depends on event type:

star start type: 0 = enable ports, 100 = disable ports

disable state can be one of the following: 1 - Online, 2 - Offline, 3 - Testing, 4 - Faulty,

5 - E_Port, 6 - F_Port, 7 - Segmented.

enable mode: 0 = normal, non-zero = loopback

ioctl I/O control arguments. Refer to Table 1-15 for a list of ioctl code values.

Tx & Rx first two header words and first payload word

reject FC-PH reject reason

busy FC-PH busy reason

ctin Argument 0 is divided into two 16-bit fields:

[A] bit map indicating validity of subsequent args

(0001 = argument 1 is valid, 0003 = arguments 1 and 2 are valid).

[B] ct-based service command code. Argument 1 = first word of the CT payload, if

applicable (as specified in [A]). Argument 2 = second word of the CT payload,

if applicable (as specified in [A]).

ctout Argument 0 is divided into two 16-bit fields:

[A] bit map indicating validity of subsequent args (0001 = argument 1 is valid,

0003 = arguments 1 and 2 are valid).

[B] CT command code indicating an accept (8002) or a reject (8001). If [B] is an

accept, argument 1 and 2 represents the first and second words of the CT

payload, if applicable (as specified in [A]). If [B] is a reject, argument 1

contains the CT reject reason and explanation code.

errlog Error type (see errShow) create - name of the task being created

loopscn description depends on loop state:

OLP offline reason code, usually zero

LIP Reason code for LIPs initiated by FL_Port, if the code value is 800x (x =

[1,0xc], see below), or the lower two bytes of the LIP received, if the code

value is other than 800x. Refer to Table 1-16 for a list of LIP code values.

LIM usually zero BMP: memory address for the loop bitmap

OLD usually zero

TMO Encoded value of state when loop initialization timed out. This value is usually

equal to the first word of a loop initialization frame payload. Refer to

Table 1-17 for a list of TMO code values.

Table 1-13 portLogShow Command Field Descriptions (Continued)

Field Possible Values