Fabric OS Reference Manual (Version 3.0)

1-108 Fabric OS Reference

Telnet Commands

ipAddrSet

Set ethernet and FC IP addresses.

Synopsis ipAddrSet

Availability admin

Description Use this command to set the ethernet and FC IP addresses. You are prompted for:

Ethernet IP Address IP address of the ethernet port.

Ethernet Subnetmask IP subnet mask of the ethernet port.

Fibre Channel IP Address IP address of the Fibre Channel ports.

Fibre Channel Subnetmask IP subnet mask of the Fibre Channel ports.

Gateway Address IP address of the gateway.

After each prompt the current value is shown. You may:

• Press return to retain the current value

• Enter an IP address in conventional dot notation

• Enter none

• Press control-C to cancel changes

• Press control-D to accept changes and end input

The final prompt allows you to set the new IP addresses immediately; enter y to set new addresses

immediately, enter n to delay the changes until the next switch reboot. Entering y closes the telnet

session.

The default IP address for a switch is 10.77.77.77.

A change to these values issues a domain address format RSCN, refer to FC-FLA for a description

of RSCNs.

Operands None.

Example To enable IP over Fibre Channel: