HP StorageWorks ESL E-Series Tape Library Users Guide (350799-010, September 2007)

• Verify that the designated car tridge is present and properly seated. (For a tape drive, make sure
the ca r tridge is completely unloaded.) Then, retry the comm and.
• Perform an inventory.
• If the erro r persists, contact a field service engineer.
A move command failed
• Check the source and destination. The source should hold the cartridge to be moved; the
destination should be empty.
• Make sure the
picker is empty and that there are no obstructions.
• Also, make sure the library is on-line and the Stop button is released.
• Retry the command.
A flash m emory error is reported
Contact your service provider
A m aximum temperature exceeded warning is displayed
• Turn off the library and allow it to cool down. Lower the room temperature, if possible, and
increase ventilation around the library.
• The air filt
ers may need to be changed.
• If the operating temperature is too high, the library automatically shuts down until the temperature
drops.
Switch problems
11653
1
2
3
4
Figure 52 LEDs on t h e switch for the internal n etwork
Table 12 describes the meaning of the status indicator LEDs for the switch for the internal network.
76
Maintenance and troubleshooting