HP StorageWorks ESL E-Series Tape Library users guide (350799-010, October 2007)

• Use the cleaning tape more than once if a tape has severely contaminated the d rive heads. If
the problem persists after two cleanings, and the cleaning tape has not expired, contact your
authorized service provider.
NOTE:
DonotuseaDLT,DLT1,orVScleaningtape(almondincolor)inanSDLTdrive.SDLTcleaningtapes
are gray and use a 7- or 8-character bar code label, CLNxxxS or CLNxxxS1.
To clean the tape heads:
1. Move a cleaning cartridge into the drive using your application software. The tape drive
automatically loads the car tridge and cleans the heads.
During the cleaning cycle the drive’s green Ready LED flashes. At the end of the cleaning cycle,
the drive ejects the cartridge.
2. Remove the cleaning cartridge from the drive.
Cleaning Ultrium tape drives
Be aware of the following:
• Ultrium tape drives have been developed to have a minimal cleaning requirement.
• An HP Ultrium Universal Cleaning Car tridge can be used up to 50 times. If you are using an
older HP Ultrium cleaning cartridge, check the documentation that came with your med ia.
CAUTION:
Only use HP Ultrium Universal Cleaning Cartridges in Ultrium tape drives.
• If the cleaning cartridge is ejected imm ediately, then it has expired or is not an Ultrium cleaning
cartridge. Discard it and use a new one.
To clean the tape heads:
1. Move a cleaning cartridge into the drive using your application software. The tape drive
automatically loads the cartridge and cleans the heads. The cleaning cycle can take up to five
minutes.
2. Move the cleaning cartridge back to the proper storage bin using your application software.
86
Maintenance and troubleshooting