HP StorageWorks ESL E-Series Internal Network Kit Installation and Replacement Instructions (AH997-96003, December 2010)

Installing the switch
9 Attach the brackets to the new switch
Use a #2 Phillips screwdriver.
10 Plug the power cable into the back
of the switch
11 Remove the screws from the drive
clusters
If you are replacing the switch, skip this step because the screws will
already be removed.
Keep the screws to use for attaching the switch to the cabinet.
12 Insert the switch into the cabinet and
attach it with the screws
Route the power cable so it will reach the PDU. Use a #2 Phillips
screwdriver to tighten the screws.
Page 3