HP StorageWorks ESL E-Series Internal Network Kit Installation and Replacement Instructions (AH997-96003, December 2010)

3 Unplug the switch's power cable from
the top of the PDU
4 Label the cables plugged into the
switch
Label the cables or write a note that shows the locations of all the cables
plugged into the switch to make it easier to reconnect them later.
5 Unplug all cables from the switch
6 Remove the switch from the cabinet
Remove the screws that attach the switch to the cabinet with a #2 Phillips
screwdriver and remove the switch from the cabinet. Keep the screws
to use for attaching the new switch.
7 Unplug the power cable from the back
of the switch
Keep the power cable to use on the new switch.
8 Remove the brackets from the switch
Use a #2 Phillips screwdriver. Keep the brackets and screws to use with
the new switch.
Page 2