HP StorageWorks ESL E-Series Interface Manager card CompactFlash replacement instructions (368005-009, August 2008)

ManualsBrandsHP ManualsStorageHP StorageWorks ESL 286e SDLT Tape Library

HP StorageWorks ESL E-Series

Interface Manag

er card

CompactFlash replacement

instructions

You can use this 1 GB CompactFlash only on the

34025 2-003 Interface Manager card. This version of

the Interface Manager card contains a label with t he

part number “AS#340252-003”, has a USB port next

to the serial port, and has the word “DUAL” printed

on the bezel. You cannot use this CompactFlash on

the 340252-001 or 340252-002 Interface Manager

cards.

Second edition: August 2008

The information in this document is subject to change without

notice.

Printed in the US

www.hp.com

8005-009

CAUTION:

Parts can be damaged by electrostatic discharge. Keep parts in

theircontainersuntilneeded.Makesurethatyouareproperly

grounded when touching static -sensitive components.

CAUTION:

This part is NOT hot-pluggable. You must power off the library to

replace this part.

CAUTION:

This procedur

ecausesallInterfaceManagercardconﬁguration

settings to be lost. You must reconﬁgure the Interface Manager

card after re

placing the CompactFlash card.

Determine the IP address conﬁguration

If possible, determine whether the Interface Manager card’s IP address

is static or dynamic. Yo u might be able to determine this from the

Operator Control Panel (O CP), the Interface Manager user interface,

or other records.

• If the IP address is dynamic, go to the next step.

• If the IP address is static, write down the IP address, default gateway,

and subnet mask. You will need this information to reconﬁgure the

Interface Manager card.

Power of

f the library

Use your backup sof tware or t he Operator Control Panel (OCP) to

empty the picker or to verify that the picker is empty.

On the front of the library, push the power button to turn off the library

(the button will extend).

Open the library door

10002

Open the back door of the library.

Page 1

Summary of content (4 pages)

PAGE 1
HP StorageWorks ESL E-Series Interface Manager card CompactFlash replacement instructions CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Make sure that you are properly grounded when touching static-sensitive components. CAUTION: This part is NOT hot-pluggable. You must power off the library to replace this part. CAUTION: This procedure causes all Interface Manager card configuration settings to be lost.
PAGE 2
Note the location of the cable connected to the Interface Manager card, and then unplug the cable. 10028a Page 2 With the connector going in first, align the sides of the CompactFlash card with the slot on the Interface Manager card. Gently slide the CompactFlash card into the slot until it is securely seated. If the CompactFlash card does not slide in easily, it is upside down.
PAGE 3
Reinstall the Interface Manager card Verify that the power cables are firmly in place. Flip the two breaker switches on (to the right) at the power distribution unit. On the front of the library, push the power button to turn on the library (the button will depress). The library will take 20 minutes or more to boot, depending on the configuration. Verify that the current state of the library that appears in the System State display on the OCP is “Online, OK”.
PAGE 4
b. Select the name of the original library, and then select Actions > Remove Library. Confirm that you want to remove the library. 2. Use FTP to transfer the firmware file to a temporary storage area in the Interface Manager card’s memory. c. a. To determine the IP address to use, look at the OCP on the front of the library. From the Home screen, select the Status tab, and then select Identity Screen. b.