HP StorageWorks ESL E-Series Counterweight Cable and Vertical Sensor Cable installation instructions (AA934-96005, August 2008)

8. Plug in the new ve

rtical sensor cable. Orient the connector so the

wires point down

9. Install a tie wr

ap around both of the cables that are on the bottom

of the robot.

10. Move the robot

down to the bot tom of the cabinet so you can see

the sensor thr

ough the cutout.

11 . Attac h the ve

rtical sensor to the robot with two screws. The vertical

sensor can be

oriented in either direction.

IMPORTANT:

Be careful not to drop the screws.

12. Close the front doors of the library.

13. Turn on the library.

Getting help

• HP product

information: h

ttp://www.hp. com/go/storage

• HP techni

cal support and phone numbers:

http://www.hp.com/support

• HP StorageWorks Library and Tape Tools (L&TT) diagnostic software:

ttp://www.hp. com/support/tapetools

• HP StorageWorks Interface Manager and Command View for Tape

Libraries Software: h

ttp://www.hp.com/support/cvtl

• HP manuals: http://www.hp.com/support/manuals

Page 4