HP StorageWorks ESL E-series Cluster Controller Installation Poster (December 2005)

12
Power on the library.
a. Verify that power cables are firmly in place.
b. Press the power button located behind the
laptop tray.
c. After several seconds, verify that the current
state of the library appears in the System
State display on the front panel (“System On-
line” or “System Off-line”).
Note: To change the state, press the
Standby button on the front panel.
This toggles the library between on-line
and off-line states.
14
Close the back door of the library.
13
Verify that the status LED is green.
11
Flip the two breaker switches on at the power
distribution unit.
Getting help
• HP product information:
http://welcome.hp.com/country/us/en/
prodserv/storage.html
• HP technical support and phone numbers:
http://www.hp.com/support
• HP StorageWorks Library and Tape Tools
(L&TT) diagnostic software:
http://www.hp.com/support/tapetools
• Interface Manager and HP StorageWorks
Command View TL:
http://www.hp.com/support/cvtl