Maximizing Efficiency Through Data Replication Manager Data Movement Application Notes

Procedures and Examples
Application Notes - Maximizing Efficiency Through Data Replication Manager Data Movement 55
Example Display 60
Connection Unit
Name Operating system Controller Port Address Status Offset
.
.
.
BUILDNGCA PPRC_TARGET THIS 2 offline 0
HOST_ID=5000-1FE1-0000-FE00 ADAPTER_ID=5000-1FE1-0000-FE04
BUILDNGCB PPRC_TARGET OTHER 2 offline 0
HOST_ID=5000-1FE1-0000-FE00 ADAPTER_ID=5000-1FE1-0000-FE02
BUILDNGCC PPRC_INITIATOR THIS 2 offline 0
HOST_ID=5000-1FE1-0000-FE00 ADAPTER_ID=5000-1FE1-0000-FE04
BUILDNGCD PPRC_INITIATOR OTHER 2 offline 0
HOST_ID=5000-1FE1-0000-FE00 ADAPTER_ID=5000-1FE1-0000-FE02
.
.
.
T 11. Remove access for each LUN from the old initiator controller (refer to callout 6 on Figure 14).
Use the commands:
SET UnitName DISABLE_ACCESS_PATH=ALL
Example: set d1 disable_access_path=all
DELETE ConnectionName
Example: delete buildngAa
Example: delete buildngAb
Example: delete buildngAc
Example: delete buildngAd
T 12. Add the remote copy sets between the new initiator and new target controllers (refer to callout 7
on Figure 14). Use the commands:
ADD REMOTE_COPY_SETS RemoteCopySetName InitiatorUnitName RemoteNodeName\TargetUnitName
Example: add remote_copy_sets rcs1 d1 buildngc\d1
Refer to Example Display 61 for a sample completion message. The instance code confirms that
the action was performed.
Example Display 61
%EVL--BUILDNGB Top-> --23-JAN-2001 10:10:56 (time not set)-- Instance Code: 0E010064
.
.
.
Instance Code: 0E010064
T 13. Let the remote copy set completely normalize. Check the status of the target state with the
following command:
SHOW REMOTE_COPY_SETS FULL
Refer to Example Display 62 for a sample display output from the SHOW command. This is
followed by a completion message. The instance code of completion message confirms
normalization has occurred.