Maximizing Efficiency Through Data Replication Manager Data Movement Application Notes

Procedures and Examples
Application Notes - Maximizing Efficiency Through Data Replication Manager Data Movement 27
I 12. From the initiator site, resume the original remote copy set and allow it to merge any new data that
may have been written since starting the data movement (refer to callout 6 on Figure 10). Use the
following command:
SET RemoteCopySetName RESUME=ControllerName\DeviceName
Example: set rcs1 resume=BUILDNGB\d1
Refer to Example Display 17 for a sample completion message. The instance code confirms that
the data merging has commenced.
Example Display 17
%EVL--BUILDNGA Top-> --16-JAN-2001 07:24:17 (time not set)-- Instance Code: 0E220064
.
.
.
Instance Code: 0E220064
I 13. Allow the merge to complete. Check the target state status with the following command:
SHOW REMOTE_COPY_SETS FULL
Refer to Example Display 18 for a sample display output from the SHOW command. This is
followed by a completion message.
Example Display 18
Name Uses Used by
------------------------------------------------------------------------------
RCS1 remote copy D1 AS1
Reported LUN ID: 6000-1FE1-0000-1530-0009-9231-4229-009A
Switches:
OPERATION_MODE = SYNCHRONOUS
ERROR_MODE = NORMAL
FAILOVER_MODE = MANUAL
OUTSTANDING_IOS = 200
Initiator (BUILDNGA\D1) state:
ONLINE to this controller
Not reserved
Target state:
BUILDNGB\D1 is MERGING 2% complete
RCS3 remote copy D3 AS1
Reported LUN ID: 6000-1FE1-0000-1530-0009-9231-4229-0093
Switches:
OPERATION_MODE = SYNCHRONOUS
ERROR_MODE = NORMAL
FAILOVER_MODE = MANUAL
OUTSTANDING_IOS = 200
Initiator (BUILDNGA\D3) state:
ONLINE to this controller
Not reserved
Target state:
BUILDNGB\D3 is NORMAL
%EVL--BUILDNGA Top-> --16-JAN-2001 07:27:37 (time not set)-- Instance Code: 0E110064
.
.
.
Instance Code: 0E110064