Maximizing Efficiency Through Data Replication Manager Data Movement Application Notes

Procedures and Examples
Application Notes - Maximizing Efficiency Through Data Replication Manager Data Movement 25
T 8. From the target site, create a remote copy set between the renamed target LUN (D10) and the
available LUN at the third site (refer to callout 3 on Figure 10). Use the following command:
ADD REMOTE_COPY_SETS RemoteCopySetName InitiatorUnitName RemoteNodeName\TargetUnitName
Example: add remote_copy_sets rcs10 d10 BUILDNGC\d10
Refer to Example Display 13 for a sample completion message. The instance code confirms that
the action was performed.
Example Display 13
%EVL--BUILDNGB Top-> --16-JAN-2001 06:57:02 (time not set)-- Instance Code: 0E010064
.
.
.
Instance Code: 0E010064
T 9. Let the remote copy set completely normalize. Check the status of the target state with the
following command:
SHOW REMOTE_COPY_SETS FULL
Refer to Example Display 14 for a sample output display from the SHOW command. This is
followed by a completion message. The instance code of completion message confirms
normalization has occurred.
Example Display 14
Name Uses Used by
------------------------------------------------------------------------------
RCS10 remote copy D10
Reported LUN ID: 6000-1FE1-0008-D4E0-0001-8290-1711-0692
Switches:
OPERATION_MODE = SYNCHRONOUS
ERROR_MODE = NORMAL
FAILOVER_MODE = MANUAL
OUTSTANDING_IOS = 200
Initiator (BUILDNGB\D10) state:
ONLINE to this controller
Not reserved
Target state:
BUILDNGC\D10 is NORMALIZING 0% complete
%EVL--BUILDNGB Top-> --16-JAN-2001 07:17:42 (time not set)-- Instance Code: 0E030064
.
.
.
Instance Code: 0E030064
T 10. Delete the remote copy set from the original target site (BUILDNGB) with the following
command (refer to callout 4 on Figure 10):
DELETE RemoteCopySetName
Example: delete rcs10
Refer to Example Display 15 for a sample completion message. The instance code confirms that
the action was performed.