Maximizing Efficiency Through Data Replication Manager Data Movement Application Notes

Procedures and Examples
22 Application Notes - Maximizing Efficiency Through Data Replication Manager Data Movement
Example
Several SHOW commands are included at the beginning of this procedure to show the initial
conditions at the initiator site.
NOTE: There is an association set with a write history log disk on the LUN with data to be moved.
I 1. Issue this command to show all units configured to the initiator controller:
SHOW UNITS
Example Display 7 shows a sample output of this command.
Example Display 7
LUN Uses Used by
------------------------------------------------------------------------------
D1 DISK10000 BUILDNGA\RCS1
D3 DISK30000 BUILDNGA\RCS3
D5 M5 AS1
I 2. Display the remote copy set status using the following command:
SHOW REMOTE_COPY_SETS FULL
Example Display 8 shows a sample output of this command.
Example Display 8
Name Uses Used by
------------------------------------------------------------------------------
RCS1 remote copy D1 AS1
Reported LUN ID: 6000-1FE1-0000-1530-0009-9231-4229-009A
Switches:
OPERATION_MODE = SYNCHRONOUS
ERROR_MODE = NORMAL
FAILOVER_MODE = MANUAL
OUTSTANDING_IOS = 200
Initiator (BUILDNGA\D1) state:
ONLINE to this controller
Not reserved
Target state:
BUILDNGB\D1 is NORMAL
RCS3 remote copy D3 AS1
Reported LUN ID: 6000-1FE1-0000-1530-0009-9231-4229-0093
Switches:
OPERATION_MODE = SYNCHRONOUS
ERROR_MODE = NORMAL
FAILOVER_MODE = MANUAL
OUTSTANDING_IOS = 200
Initiator (BUILDNGA\D3) state:
ONLINE to this controller
Not reserved
Target state:
BUILDNGB\D3 is NORMAL
I 3. Display the status of association sets known to the controller using the following command:
SHOW ASSOCIATIONS
Example Display 9 shows a sample output of this command.