HP StorageWorks Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide (AA-RPHZF-TE, March 2004)

Configuring a Standard Data Replication Manager Solution
82 Data Replication Manager HSG80 ACS Version 8.7P Configuration Guide
Example Display 16
Class I H/W Path Driver S/W State H/W Type Description
disk 0 0/0/1/1.2.0 sdisk CLAIMED DEVICE SEAGATE ST39204LC
/dev/dsk/c1t2d0 /dev/rdsk/c1t2d0
disk 1 0/0/255.0.0.0 sdisk CLAIMED DEVICE HSG80 LUN
0x60001FE100080D100009834019820144
/dev/dsk/c12t0d0 /dev/rdsk/c12t0d0
Note: If the device special files (/dev/dsk/c12t0d0 /dev/rdsk/c12t0d0, for example) are not
displayed, then issue the insf -e command to install special files, then repeat the ioscan
-fnCdisk command.
Configure the SWCC Agent (Optional)
T The SWCC Agent may now be installed and configured. Refer to the HP StorageWorks
HSG80 ACS Solution Software Version 8.7 for HP-UX Installation and Configuration Guide,
Chapter 4, for installation instructions.
Additional Setup
T You may now configure volume groups, logical volumes, and file systems on any nonremote
copy set LUNs on the storage arrays using normal HP-UX procedures.
Your HP-UX host is now configured to use DRM. Repeat this procedure for each HP-UX host
present at your target site. After configuring the target site hosts, go to the section titled
“Configure the Controllers at the Initiator Site” on page 100.
IBM AIX
Before starting this procedure, make sure that your host is up to date with service packs and
patches. For supported revision levels, refer to the DRM Release Notes.
Install the HBAs
You must install at least two HBAs in each host system. HBAs must be installed in pairs. You
may install a maximum of six adapters per host, but two adapter pairs must not share the same
unit on the RAID system.
T Power down your AIX host and install the HBAs in any of the free PCI slots. The HBAs work
in either a 32-bit or 64-bit PCI card slot.
Note: Do not attach your fiber connections to the HBAs at this time and do not install the AIX driver
that comes with the Cambex HBA. The driver is installed in the following step.