Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

4–38 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
3. Using the String Editor, make sure the value of Topology in the string is equal to 1.
This will tell the driver to operate in a Fibre Channel switched environment.
4. Exit the Registry Editor.
Install Secure Path (NT only)
For installation information, refer to the StorageWorks Secure Path for Windows NT, A
High Availability MultiPath Solution, Installation Guide.
1. Verify that the Secure Path Agent is installed by going to the control panel and
selecting services. The Secure Path Agent should be set for automatic start up. Verify
that HSZDisk and RAIDisk are also installed by going to the control panel and
selecting devices.
2. Use the Secure Path Agent Configuration to grant access to the client at both the
initiator and target sites. This can be found by following these menus:
● Program Files
● StorageWorks
● Secure Path Agent
● Secure Path Cfg
3. You can set the password and allow client access via the Secure Path Agent
Configuration.
NOTE: Compaq recommends that you set both the fully qualified and unqualified DNS names as
valid, authorized clients.
4. Reboot the host.
Install SWCC (optional)
Detailed information about SWCC can be found in the CompaqStorageWorks Command
Console Getting Started Guide.
Connecting Fibre Optic Cables Between the Hosts and the Switches
1. Connect a multi-mode, 50-micron fiber optic cable from port 0 of the top switch to
the host.
2. Connect the final multi-mode, 50-micron fiber optic cable from port 0 of the bottom
switch to the host.