Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

4–28 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
29. You are now ready to enable Data Replication Manager. Use the following CLI
command:
SET THIS_CONTROLLER REMOTE_COPY=InitiatorName
Example: SET THIS_CONTROLLER REMOTE_COPY=BuildngA
NOTE: Be sure to specify a meaningful InitiatorName. Do not use “local” and “remote”; these
are reserved keywords. The name can be up to eight characters and must be unique to all of
your controllers. Follow the naming guidelines as specified in the HSG80 Array Controller ACS
Version 8.5 Configuration Guide,.
After you have entered this CLI command, you will see a series of %LFL and %EVL
displays, and the controllers will automatically restart.
30. Use the following CLI command to verify that these settings are in place:
SHOW THIS_CONTROLLER
.
Host PORT_2:
Reported PORT_ID = nnnn-nnnn-nnnn-nnnn
PORT_2_TOPOLOGY = FABRIC (offline)
REMOTE_COPY = BuildngA
.
Configure the Storage at the Initiator Site
Devices and StorageSets
Before you can configure the storage for Data Replication Manager, you need to add the
disks, create the RAIDsets, and create units. Follow the instructions in the HSG80 Array
Controller ACS Version 8.5 Configuration Guide, but note the restrictions listed at the
beginning of this chapter.
NOTE: Keep in mind that the initiator site must have the same exact storageset and unit
configuration as the target site.
Units
Refer to the HSG80 Array Controller ACS Version 8.5 Configuration Guide, for detailed
information.
Once all of the units have been created, you can proceed to the following steps.