Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

4–14 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
The display will be similar to the following:
LUN Uses Used by
------------------------------------------------------------------------------
D110 DISK1000
LUN ID: nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn-nnnn
NOIDENTIFIER
Switches:
RUN NOWRITE_PROTECT READ_CACHE
READAHEAD_CACHE WRITEBACK_CACHE
MAXIMUM_CACHED_TRANSFER_SIZE = 32
Access:
None
State:
ONLINE to this controller
Not reserved
NOPREFERRED_PATH
Size: nnnnnnnn blocks
Geometry (C/H/S): ( 7000 / 20 / 254 )
.
.
.
NOTE: For OpenVMS, all units must have an identifier set.
4. For OpenVMS, set device ID on all units with the following command:
SET UNIT IDENTIFIER = value
Example: SET D1 ID = 1
This becomes the VMS device ID for DGA1.
5. To ensure that your storage settings are in place, use the following CLI command:
SHOW StoragesetName FULL
Connect Fiber Optic Cables Between the Controllers and Fiber Channel Switches
This procedure specifies how to make fiber optic connections. Figure 4–2 shows the port
locations on the switch.
Figure 4–2. Switch Port Locations
CXO7085A