Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide

4–12 Compaq StorageWorks Data Replication Manager HSG80 ACS Version 8.5P Operations Guide
25. Set the fabric topology for each port on both controllers using the following CLI
commands:
NOTE: You will be prompted to restart the controllers after each command, but you do not need
to restart the controllers until all topologies have been set.
SET THIS_CONTROLLER PORT_1_TOPOLOGY=FABRIC
SET THIS_CONTROLLER PORT_2_TOPOLOGY=FABRIC
SET OTHER_CONTROLLER PORT_1_TOPOLOGY=FABRIC
SET OTHER_CONTROLLER PORT_2_TOPOLOGY=FABRIC
26. Restart the controllers (in this order) with the following CLI commands:
RESTART OTHER_CONTROLLER
RESTART THIS_CONTROLLER
27. To verify that the topology is set correctly, issue the following CLI command:
SHOW THIS_CONTROLLER
.
.
.
Host PORT_1:
Reported PORT_ID = nnnn-nnnn-nnnn-nnnn
PORT_1_TOPOLOGY = FABRIC (offline)
Address =nnnnnn
Host PORT_2:
Reported PORT_ID = nnnn-nnnn-nnnn-nnnn
PORT_2_TOPOLOGY = FABRIC (offline)
Address =nnnnnn
NOREMOTE_COPY
.
.
.
NOTE: If the port_1_topology = fabric (point-to-point) is displayed, this indicates a switch
configuration error. Please refer to the StorageWorks Fibre Channel Storage Switch User’s
Guide.
28. You are now ready to enable data replication. Use the following CLI command:
SET THIS_CONTROLLER REMOTE_COPY=TargetNodeName
Example: SET THIS_CONTROLLER REMOTE_COPY=BuildngB
NOTE: Be sure to specify a meaningful TargetName such as a name that reflects the Target’s
location. Do not use “local” and “remote”; these are reserved keywords. The name can be up to
eight characters and must be unique to all of your controllers. Follow the naming guidelines as
specified in the HSG80 Array Controller ACS Version 8.5 Configuration Guide.